TicWatch C2 Power Button Repair

Power Button Repair is one of the most common repairs for TicWatch C2. This repair involves replacing the damaged input component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.

What You'll Need

• Replacement input part (OEM or aftermarket)
• Precision screwdriver set (Phillips #000 or pentalobe)
• Opening tools (plastic spudger, suction cup)
• Adhesive strips or glue
• Clean workspace with good lighting

Step-by-Step Process

Step 1: Remove the plastic shell

With a sharp and thin object, press and open the plastic shell, equipped with the charging connectors, upwards. It is attached with glue , to facilitate , it can also be heated. Do not completely remove the shell but lift it because the connector is attached to the mainboard.

Step 2: Open and disconnect charging connector

Lift the plastic cover and disconnect the charging connector from the mainboard.

Step 3: Disconnect other peripherals

Disconnect the other 4 connectors that remain to remove the battery and mainboard block.

Step 4: Remove Mainboard and batteri block from front housing

Remove mainboard and battery block from display front housing

Step 5: Remove Mainboard and battery from plastic shell

With a philips screwdriver remove the two screws that hold the mainboard and the battery to the plastic shell.

Step 6: Final remove battery

The battery is held on the mainboard with little glue.Easy to remove

DIY vs Professional Repair

Environmental Impact

By choosing to repair your TicWatch C2 instead of replacing it, you're preventing approximately 28 kg of CO₂ emissions. Manufacturing a new TicWatch C2 generates 31 kg of CO₂, while this repair only produces about 3 kg of CO₂. That's a 90% reduction in carbon emissions!