Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Display
moderate

Nokia T12 Screen Replacement

Complete guide to Nokia T12 screen replacement. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$80 - $350
⏱️ Time:1-2 hours
🌍 CO₂ Saved:92 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$48 - $210
Labor$32 - $140
Total Estimated Cost$80 - $350

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Screen Replacement is one of the most common repairs for Nokia T12. This repair involves replacing the damaged display component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.

🔧 Required Tools

What You'll Need

  • Replacement display part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1
Step 1 - Image 2

Turn off the phone.

Remove the battery and any installed SIM and memory cards. There are two tapes screws:

4x Torx T6

5x Torx T5

Remove the middle bezel.

Earpiece Flex Cable

Loudspeaker / Ringer

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Disconnect the touch screen & display flex cable.

Remove the main board.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

If the glass is broken, put some scotch tape to prevent it breake to pieces.

Use a hot air to make adhesive tape more soften.

For this operation you can use a hairdryer.

Use a cutter and make small room to insert a plastic pick.

Step 4:

Step 4 - Image 1
Step 4 - Image 2

Continue with the separation by using a plastic tools.

If necessary, use the hot air again

Step 5:

Step 5 - Image 1
Step 5 - Image 2

Unstuck the Touch screen flex cable from the display.

If you have a broken glass, you can cut the touch screen flex cable, otherwise unsolder it careful like in the next step.

Step 6:

Step 6 - Image 1
Step 6 - Image 2

The display edges are glued to the glass with adhesive tape.

Use only thin plastic tools for the separation.

Step 7:

Step 7 - Image 1
Step 7 - Image 2

Remove the blue sticker.

With a soldering iron, remove the touch screen flex cable and install the new one.

Put back the blue sticker.

Step 8:

Step 8 - Image 1
Step 8 - Image 2

If the spare part is without tape, install a new one.

Carefully put the display in place, then install the glass.

Start with reassembling.

Step 9:

Step 9 - Image 1

That's all.

'''Did you do it successfully?'''

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Moderate | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $48-$210)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($80-$350)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your Nokia T12 instead of replacing it, you're preventing approximately 92 kg of CO₂ emissions. Manufacturing a new Nokia T12 generates 100 kg of CO₂, while this repair only produces about 8 kg of CO₂. That's a 92% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your Nokia T12 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides