HP Envy 2023 Screen Replacement
Complete guide to HP Envy 2023 screen replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Screen Replacement is one of the most common repairs for HP Envy 2023. This repair involves replacing the damaged display component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
🔧 Required Tools
🔩 Replacement Parts
What You'll Need
- Replacement display part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Turn the laptop over and use the plastic opening tool to take off the rubber pads. You only need to take off the two pads at the top for this device.
Step 2:
Use the Torx T5 screwdriver to remove the six small screws.
Use the Phillips #0 screwdriver to remove the screws under the rubber pads in step 1.
Step 3:
Go slowly around the edge with the opening tool. The noises you will hear are due to the small joints popping open. Continue this until you have made your way around the entire laptop.
Step 4:
Remove the six 4mm screws around the battery using a Phillips #0 screwdriver.
Step 5:
Disconnect the white connector from the battery to the board. (It is recommended to use pliers to remove the cord to avoid touching the board).
Once the connector and screws are both removed, lift the battery up and remove it from the laptop.
The removal of the connector and the screws can be done in either order.
Step 6:
Make sure the the back panel is placed back on the computer so none of the internal components are exposed.
Open laptop and lay it completely flat.
Step 7:
Place the suction cup directly on the screen and apply pressure so that the cup is firmly in place.
Step 8:
Take the opening tool and wedge it between the rubber lining around the screen and the back panel and begin to pry it open by lifting up.
Step 9:
To take the screen out of the back panel, simultaneously pull on the suction cup while creating leverage between the back panel and the rubber lining.
Popping sounds are expected.
Step 10:
Once the screen is detached from the back panel, direct your attention to the back of the screen where you will remove the tape holding the screen to the bottom panel.
Remove the grey tape covering the wires on both sides by slowly pulling back the tape as not to separate the tape from the adhesive.
Step 11:
Remove the slender black wire that is connected to the bread board by sliding the cable backwards.
Pull down on the tape connected to the cable while sliding it out in order to completely detach all screen connections from the back panel.
Step 12:
Once steps 1-6 are completed, place a hand on the edge of the screen and slowly pull the screen away from the back panel and remove it from the device.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $48-$210)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($80-$350)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your HP Envy 2023 instead of replacing it, you're preventing approximately 257 kg of CO₂ emissions. Manufacturing a new HP Envy 2023 generates 265 kg of CO₂, while this repair only produces about 8 kg of CO₂. That's a 97% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your HP Envy 2023 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.