Acer Predator Helios 300 Screen Replacement
Complete guide to Acer Predator Helios 300 screen replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Screen Replacement is one of the most common repairs for Acer Predator Helios 300. This repair involves replacing the damaged display component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
🔧 Required Tools
🔩 Replacement Parts
What You'll Need
- Replacement display part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Before you start make sure the laptop is grounded.
Make sure the laptop is powered off.
If the laptop is not turned off, there is a risk of electric shock when replacing the battery.
Close the cover of the laptop, then turn the laptop upside down so the back is facing up.
Step 2:
Remove all the screws from the back panel with a Phillips #0 screwdriver.
Remove the hard drive screw using a Phillips #0 screwdriver.
Use the panel tool to pop the storage hard disk open.
Step 3:
Remove the four screws mounted near the storage hard disk using a Phillips #0 screwdriver.
Disconnect the cable connected to the storage hard disk.
Step 4:
Use the panel tool to remove the back cover.
Slowly open the clips attached to the back cover, and store the cover safely.
Step 5:
Remove the tape holding the battery wires in.
Remove the two screws mounted next to the battery using a Phillips #0 screwdriver.
Disconnect the battery cable from the motherboard slowly.
Remove the old battery.
Step 6:
The battery is a ***Household Hazardous Waste,*** so be sure to follow your city's laws and dispose of them properly.
Connect the new battery connector to the motherboard and screw it back with the screwdriver.
Step 7:
Align the back cover with the laptop properly and click it with all the clips.
Step 8:
Insert the storage disk back in.
Connect it with the cable first and then fit it inside the missing space.
Fasten the remaining screws using a screwdriver.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $48-$210)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($80-$350)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your Acer Predator Helios 300 instead of replacing it, you're preventing approximately 317 kg of CO₂ emissions. Manufacturing a new Acer Predator Helios 300 generates 325 kg of CO₂, while this repair only produces about 8 kg of CO₂. That's a 98% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your Acer Predator Helios 300 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.