Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Power
moderate

Samsung Galaxy A11 Battery Replacement

Complete guide to Samsung Galaxy A11 battery replacement. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$50 - $200
⏱️ Time:30 min - 1 hour
🌍 CO₂ Saved:55 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$30 - $120
Labor$20 - $80
Total Estimated Cost$50 - $200

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Battery Replacement is one of the most common repairs for Samsung Galaxy A11. This repair involves replacing the damaged power component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires moderate skill level.

🔧 Required Tools

What You'll Need

  • Replacement power part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1
Step 1 - Image 2

Place the SIM eject tool in the hole of the sim tray.

Push until part of the SIM tray is pushed out.

Pull out the rest of the SIM tray.

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Gently pry open the area of the back cover near the SIM tray using an iFixit opening pick.

Gently move the pick along the gap and pry open the clips holding it together.

If possible, use multiple picks to prevent the back cover from closing.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

Using a hair dryer on low heat, heat the fingerprint sensor in increments of 30 seconds to loosen the surrounding adhesive.

Gently push the fingerprint sensor until it detaches from the back cover.

If needed, remove the button by prying it from the bottom of the device.

Step 4:

Step 4 - Image 1
Step 4 - Image 2

Remove the three 3 mm screws from the shield using a Phillips #000 screwdriver.

Remove the shield from the phone.

Step 5:

Step 5 - Image 1
Step 5 - Image 2

Using tweezers, a spudger, or your fingers, disconnect the battery press connector from the phone.

Step 6:

Step 6 - Image 1
Step 6 - Image 2

If needed, use a hairdryer on low heat to soften the adhesive under the battery. If The Battery Is Expanded, DO NOT USE A HAIRDRYER or heat; be very careful when removing to not puncture the battery.

Use an iFixit pry tool to dig under the battery edge.

If needed, use multiple pry tools to hold the battery in place.

Continue to cut the adhesive under the battery until you are able to pry the battery away from the phone.

Remove the battery from the phone.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Moderate | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $30-$120)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($50-$200)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your Samsung Galaxy A11 instead of replacing it, you're preventing approximately 55 kg of CO₂ emissions. Manufacturing a new Samsung Galaxy A11 generates 60 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 92% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your Samsung Galaxy A11 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides