Motorola Moto G Stylus Battery Replacement
Complete guide to Motorola Moto G Stylus battery replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Battery Replacement is one of the most common repairs for Motorola Moto G Stylus. This repair involves replacing the damaged power component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires moderate skill level.
🔧 Required Tools
🔩 Replacement Parts
What You'll Need
- Replacement power part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Push a SIM tray ejector into the hole.
Remove the SIM card and tray.
Step 2:
Before you begin, discharge the battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.
Power off your phone and disconnect the charger and any peripheries before beginning disassembly.
Lay the phone face down.
Alternatively, use a hair dryer to heat the rear case until it's almost too hot to touch.
Step 3:
Insert an opening tool into the seam between the rear case and chassis.
Once you create a gap, insert an opening pick a couple of millimeters into the gap.
Slide the opening pick around the entire perimeter to sever the adhesive that secures the rear case.
If you feel excessive resistance, reheat the problem area(s).
Remove the rear case.
Step 4:
You may need to use your heating device again to remove glue from covering the screws.
Use a T4 Torx screwdriver to remove all eleven 3.2 mm screws securing the midframe.
Step 5:
Use an opening tool to lift and remove the midframe.
Step 6:
Remove the black graphite tape from the battery and surrounding components.
Use an opening tool to lift and disconnect the press connector above the battery.
Step 7:
Use an iOpener or hair dryer to gently warm the battery to loosen to adhesive that secures it.
Warm the battery until it's uncomfortable to touch for more than a few seconds.
Use a spudger to gently pry around the entire perimeter of the battery until it fully releases.
Do not deform or damage the battery.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $30-$120)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($50-$200)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your Motorola Moto G Stylus instead of replacing it, you're preventing approximately 54 kg of CO₂ emissions. Manufacturing a new Motorola Moto G Stylus generates 59 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 92% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your Motorola Moto G Stylus and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.