Motorola Edge Plus WiFi Antenna Repair
Complete guide to Motorola Edge Plus wifi antenna repair. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
WiFi Antenna Repair is one of the most common repairs for Motorola Edge Plus. This repair involves replacing the damaged connectivity component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
🔧 Required Tools
What You'll Need
- Replacement connectivity part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Press and hold the power button for 7 seconds.
You will know the phone is fully powered off when the Motorola logo appears on the screen.
Step 2:
Insert a paperclip or SIM card ejector into the small hole located at the bottom of phone.
Gently push to release and remove the SIM card.
Step 3:
Use an iOpener, heat gun, or hairdryer to gently heat the perimeter of the phone.
Insert and slide the iFixit opening pick around heated edges to sever the adhesive securing the rear cover.
Step 4:
Gently remove the back cover using the suction handle or your bare hands.
Step 5:
While applying light pressure, remove the camera bezel cover by sliding the jimmy along the edges.
Step 6:
Use a Phillips #00 screwdriver to remove the twelve 1.5 mm black screws.
In case a screw gets lost, the exact specifications for all screws in this guide are OEM MOTOROLA EDGE+ PLUS 5G UW.
Step 7:
Remove the logic board by lifting gently with the flat end of the spudger.
Step 8:
Use the flat end of a spudger to to pry up and disconnect the two press connectors on either side of the battery.
Located in the bottom left corner of the battery, remove the tape (black in the image) with a spudger.
Step 9:
Gently lift the battery up using the black spudger and remove.
Applying too much force when removing the battery may damage it. Take care not to bend, warp, or puncture the battery.
Apply a few drops of isopropyl alcohol if the battery is tightly adhered.
Step 10:
Use the flat end of a spudger to disconnect the upper camera press connector.
Wedge the spudger under the camera and apply pressure until it dislodges.
Step 11:
Use a Phillips #00 screwdriver to remove the single 1.5 mm silver screw on the motherboard.
Step 12:
Use the black spudger to remove the motherboard by lifting at the base of the board as seen in the image.
Blue and black wires may become disconnected when removing the mother board. The wires can be reconnected once the camera - attached to the motherboard - is replaced.
Step 13:
Using the flat end of the black spudger, lift under the silver connector ribbon to remove the final camera.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $36-$108)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($60-$180)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your Motorola Edge Plus instead of replacing it, you're preventing approximately 55 kg of CO₂ emissions. Manufacturing a new Motorola Edge Plus generates 59 kg of CO₂, while this repair only produces about 4 kg of CO₂. That's a 93% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your Motorola Edge Plus and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.