MacBook Air 15" 2015 Charging Port Repair
Complete guide to MacBook Air 15" 2015 charging port repair. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Charging Port Repair is one of the most common repairs for MacBook Air 15" 2015. This repair involves replacing the damaged connectivity component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires easy skill level.
🔧 Required Tools
🔩 Replacement Parts
What You'll Need
- Replacement connectivity part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Remove the following P5 pentalobe screws securing the lower case to the MacBook Pro:
Eight 3.1 mm
Two 2.3 mm
Step 2:
Lifting from the edge nearest the clutch cover, lift the lower case off the MacBook Pro.
Step 3:
The lower case has two plastic pegs (red) that fit into plastic clips in the upper case (orange).
During reassembly, gently push down the center of the lower case to reattach the case to its two plastic clips.
Step 4:
Peel back the sticker covering the battery connector.
Step 5:
Gently lift each side of the battery connector to pry the connector out of its socket on the logic board.
Bend the connector back toward the battery, ensuring that the battery connector doesn't accidentally make contact with the logic board.
Step 6:
Disconnect the three airport Antenna cable connectors from their sockets on the AirPort board and bend them up and out of the way.
Be careful to pry only against each connector, and not its cable or socket.
Step 7:
Remove the single 2.9 mm T5 Torx screw securing the AirPort board.
Step 8:
Lift the end of the AirPort board up enough to pass over the heat sink directly behind it.
Do not lift the AirPort board too high, or you could damage the contacts or socket.
Pull the AirPort board straight out of its socket on the logic board.
There is a slightly adhesive thermal pad beneath the AirPort board. Be sure to reapply this when reinstalling the board, or transfer it to your replacement board.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $24-$72)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($40-$120)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your MacBook Air 15" 2015 instead of replacing it, you're preventing approximately 187 kg of CO₂ emissions. Manufacturing a new MacBook Air 15" 2015 generates 190 kg of CO₂, while this repair only produces about 3 kg of CO₂. That's a 98% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your MacBook Air 15" 2015 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.