MacBook Air 13" 2019 Speaker Repair
Complete guide to MacBook Air 13" 2019 speaker repair. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Speaker Repair is one of the most common repairs for MacBook Air 13" 2019. This repair involves replacing the damaged audio component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires moderate skill level.
🔧 Required Tools
🔩 Replacement Parts
What You'll Need
- Replacement audio part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1: Remove the screws securing the lower case
Before starting this procedure, you should disable your Mac's '''Auto Boot''' feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. [https://www.ifixit.com/Guide/How+to+Disable+Auto+Boot/110034|Use this guide|new_window=true] to disable Auto Boot.
If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you're inside.
Completely power off and unplug your MacBook Air before you start. Close the display and flip the entire laptop upside-down.
Use a P5 driver to remove the following screws:
Two 7.9 mm screws
Two 7.1 mm screws
Six 2.6 mm screws
Step 2: Remove the lower case
Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Remove the lower case.
After reassembly, your MacBook might not turn on until it's connected to a power source (a low power phone charger may work). To test your repair, plug in your charger, allow two minutes for your MacBook to turn on, and check that everything works as expected.
Step 3: Disconnect the battery
Peel back the tape covering the battery connector enough to reveal the connector underneath.
Step 4:
Use a spudger to slide the battery connector parallel to the logic board and out of its socket on the logic board.
Step 5: Remove the right speaker adhesive
Use a pair of [product|IF145-020|tweezers] to lift up the black adhesive pull tab at the bottom of the right speaker, enough so you can grab it with your fingers.
Grab the adhesive strip pull tab and slowly and carefully pull the adhesive strip out from under the speaker.
Keep the angle of the adhesive strip as parallel to the laptop as you can. Try to avoid dragging it across the inside of the case.
If the adhesive strip breaks, leave it in and proceed to the next step.
Step 6:
Slide the tip of a spudger underneath the right speaker cable and pry straight up to disconnect the speaker.
Step 7:
Use tweezers to lift the adhesive pull tab at the top of the right speaker enough that you can grab it with your fingers.
Grab the adhesive strip pull tab and slowly and carefully pull the adhesive strip out from under the speaker.
Keep the angle of the adhesive strip as parallel to the laptop as you can. Try to avoid dragging it across the inside of the case.
If the adhesive strip breaks, or if the first adhesive strip broke, use a [https://www.ifixit.com/Guide/iOpener+Heating/25705|heated iOpener|new_window=true] or heat gun to help remove the adhesive:
Apply heat to the speaker to soften the adhesive underneath.
Carefully slide a spudger or opening pick underneath the speaker to separate the adhesive.
Step 8: Remove the right speaker
Lift the right speaker straight up from the bottom and remove it.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $30-$90)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($50-$150)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your MacBook Air 13" 2019 instead of replacing it, you're preventing approximately 172 kg of CO₂ emissions. Manufacturing a new MacBook Air 13" 2019 generates 175 kg of CO₂, while this repair only produces about 3 kg of CO₂. That's a 98% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your MacBook Air 13" 2019 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.