MacBook Air 13" 2015 Bluetooth Repair
Complete guide to MacBook Air 13" 2015 bluetooth repair. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Bluetooth Repair is one of the most common repairs for MacBook Air 13" 2015. This repair involves replacing the damaged connectivity component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
🔧 Required Tools
🔩 Replacement Parts
What You'll Need
- Replacement connectivity part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Before proceeding, power down your MacBook. Close the display and lay it on a soft surface, top-side down.
Use a [product|IF145-090|P5 Pentalobe] driver to remove ten screws securing the lower case, of the following lengths:
Two 9 mm screws
Eight 2.6 mm screws
Step 2:
Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.
Remove the lower case and set it aside.
Step 3:
To ensure that everything is de-energized and won't turn on while you're working, it is recommended that you disconnect the battery.
Grab the clear plastic pull tab attached to the battery connector and pull it parallel to the board toward the front edge of the Air.
Do not lift upward on the connector as you disconnect it or you risk damage to the connector socket.
Step 4:
Use the flat end of a spudger to pry both antenna connectors up from their sockets on the AirPort/Bluetooth card.
Step 5:
Remove the single 2.9 mm T5 Torx screw securing the AirPort/Bluetooth card to the logic board.
Step 6:
Slightly lift the free end of the AirPort/Bluetooth card and pull it out of its socket on the logic board.
To avoid damaging its socket on the logic board, do not excessively lift the free end of the AirPort/Bluetooth card.
Remove the AirPort/Bluetooth card from the Air.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $39-$114)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($65-$190)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your MacBook Air 13" 2015 instead of replacing it, you're preventing approximately 171 kg of CO₂ emissions. Manufacturing a new MacBook Air 13" 2015 generates 175 kg of CO₂, while this repair only produces about 4 kg of CO₂. That's a 98% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your MacBook Air 13" 2015 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.