Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Audio
moderate

iPhone 8 Speaker Repair

Complete guide to iPhone 8 speaker repair. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$50 - $150
⏱️ Time:30 min - 1 hour
🌍 CO₂ Saved:54 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$30 - $90
Labor$20 - $60
Total Estimated Cost$50 - $150

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Speaker Repair is one of the most common repairs for iPhone 8. This repair involves replacing the damaged audio component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires moderate skill level.

🔧 Required Tools

🔩 Replacement Parts

What You'll Need

  • Replacement audio part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1

Sim card tray removal. This step is necessary as seen in Step 7.

Let the battery drain below 25% and power off the device before starting the repair.

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Remove the two bottom screws using the P2 bit in the Pro Tech Tool Kit.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

Insert the Jimmy into the right side of the phone. Putting the Jimmy in the middle could crack the glass and/or break the home button. Also, don't put the Jimmy into the left side because you could break the home button cable. Use a small box to prop up the display as shown in picture 3.

Step 4:

Step 4 - Image 1
Step 4 - Image 2

Before we disconnect the display, we need to unplug the battery connector. If you don't unplug the battery first, you could damage the back light on the screen.

Step 5:

Step 5 - Image 1
Step 5 - Image 2

Now to remove the display. There are 3 more screws that we need to remove, then we can disconnect the 3 cables.

Remove the display from the housing.

Step 6:

Step 6 - Image 1

Now we need to remove this bracket. The screw next to the Taptic Engine is a Y000.

Step 7:

Step 7 - Image 1
Step 7 - Image 2

Disconnect the marked flex cables, then push the sim pin ejector into the frame. Now remove the 3 screws holding the speaker in place. Lift the speaker up and remove it as shown in picture 2.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Moderate | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $30-$90)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($50-$150)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your iPhone 8 instead of replacing it, you're preventing approximately 54 kg of CO₂ emissions. Manufacturing a new iPhone 8 generates 57 kg of CO₂, while this repair only produces about 3 kg of CO₂. That's a 95% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your iPhone 8 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides