Fossil Gen 7 Battery Replacement
Complete guide to Fossil Gen 7 battery replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Battery Replacement is one of the most common repairs for Fossil Gen 7. This repair involves replacing the damaged power component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires moderate skill level.
What You'll Need
- Replacement power part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Squeeze retaining pins together to release chain from watch body. This can be done by hand or with [product|IF145-020|tweezers].
Remove chain from opposing side of watch body.
Step 2:
Use tweezers to grip the notches on the back cover, then unscrew the back cover (counter-clockwise) from the watch housing.
There is an actual tool made to remove this back cover, using the right tool may save you from scratching the back of watch with tweezers. The backcover tool can be purchased online, a local jeweler may also be willing to remove it for you.
Step 3:
Utilize tweezers or a spudger or your fingers to pull the black wire connector from the motherboard.
Utilize a spudger to pull the orange connector off of the motherboard.
Step 4:
Utilize tweezers to pull the white battery connector from the motherboard.
Step 5:
The internal electronics can now be pulled out of the watch as one unit leaving the screen remaining in the watch housing.
Taking the flat end of the spudger, pry it up.
Step 6:
The battery is secured to the back of the motherboard utilizing a sticky pad. Gently separate the battery from the board while making sure not to put too much stress on the board. This is best done at the location shown.
Step 7:
Remove battery from plastic housing.
Slip wires through large slot in plastic housing to completely remove.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Easy | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $30-$120)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($50-$200)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your Fossil Gen 7 instead of replacing it, you're preventing approximately 27 kg of CO₂ emissions. Manufacturing a new Fossil Gen 7 generates 32 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 84% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your Fossil Gen 7 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.