Fitbit Charge 6 Vibration Motor Repair

Vibration Motor Repair is one of the most common repairs for Fitbit Charge 6. This repair involves replacing the damaged haptic component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires easy skill level.

🔧 Required Tools

🔩 Replacement Parts

What You'll Need

• Replacement haptic part (OEM or aftermarket)
• Precision screwdriver set (Phillips #000 or pentalobe)
• Opening tools (plastic spudger, suction cup)
• Adhesive strips or glue
• Clean workspace with good lighting

Step-by-Step Process

Step 1:

Remove the four 2.9 mm screws from the back of the display using a Torx screwdriver.

Remove the back cover from the device.

Step 2:

Remove the two 2.9 mm Torx screws holding the circuit board in place.

Carefully pry the board out using an opening tool.

Step 3:

Remove the motherboard assembly from the device by gently lifting.

Step 4:

Locate the vibration motor on the motherboard.

Desolder the red and black wires connected to the motherboard from the vibration motor.

Red wire is located closer to the outside. Black wire is closer to the inside of the motherboard.

Replace with new vibration motor.

DIY vs Professional Repair

Environmental Impact

By choosing to repair your Fitbit Charge 6 instead of replacing it, you're preventing approximately 30 kg of CO₂ emissions. Manufacturing a new Fitbit Charge 6 generates 32 kg of CO₂, while this repair only produces about 2 kg of CO₂. That's a 94% reduction in carbon emissions!