Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Recovery
difficult

Dell Inspiron 14 7000 Water Damage Repair

Complete guide to Dell Inspiron 14 7000 water damage repair. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$100 - $400
⏱️ Time:2-4 hours
🌍 CO₂ Saved:260 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$60 - $240
Labor$40 - $160
Total Estimated Cost$100 - $400

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Water Damage Repair is one of the most common repairs for Dell Inspiron 14 7000. This repair involves replacing the damaged recovery component with a new or refurbished part. The process typically takes 2-4 hours and requires difficult skill level.

🔧 Required Tools

What You'll Need

  • Replacement recovery part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1: Intro

Step 1 - Image 1

Power button with keyboard/trackpad as reference

Step 2: Open bottom cover

Step 2 - Image 1
Step 2 - Image 2

7 total phillips head screws

4 loose screws

3 captured screws

Carefully pry the bottom cover up from the rear of chassis first (by captured-screws), then follow perimeter to unlatch all plastic clips.

Step 3: Free daughter-board

Step 3 - Image 1

Remove the two screen hinge screws and turn the hinge upright slowly while holding the screen-side of hinge as shown.

Step 4: Remove daughterboard

Step 4 - Image 1
Step 4 - Image 2

Remove the two daughterboard screws

Pry up from fan-side of daughterboard and slide slightly toward the fan to free the 3.5mm jack from the chassis.

Step 5: Power button removal

Step 5 - Image 1

The daughterboard cable should be able to bend out of the way to allow access to rear of power button.

Remove two more screws holding in the power button.

*Note the unused connecter on the daughterboard marked "FPR1". This is where the new FPR cable will connect.

Step 6: Install fingerprint reader

Step 6 - Image 1
Step 6 - Image 2

Install and screw in new power button/FPR.

Route FPR cable and re-install the daughterboard.

Upend the FPR jack latch, slide in FPR connector, and lower latch to secure the cable.

Re-install hinge screws, CMOS battery, and bottom cover and screws.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Easy | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $60-$240)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($100-$400)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your Dell Inspiron 14 7000 instead of replacing it, you're preventing approximately 260 kg of CO₂ emissions. Manufacturing a new Dell Inspiron 14 7000 generates 270 kg of CO₂, while this repair only produces about 10 kg of CO₂. That's a 96% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your Dell Inspiron 14 7000 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides