Amazon Fire HD 8 (10th Gen) Camera Repair
Complete guide to Amazon Fire HD 8 (10th Gen) camera repair. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Camera Repair is one of the most common repairs for Amazon Fire HD 8 (10th Gen). This repair involves replacing the damaged optics component with a new or refurbished part. The process typically takes 30 min - 1 hour and requires moderate skill level.
🔧 Required Tools
What You'll Need
- Replacement optics part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Remove the device from any electrical source and make sure it is powered off.
Put picks around the corner and move them along the edge to pry the case off.
Once there is separation between the case and the screen, place a pick in between the screen and on the corner of the back case.
Step 2:
With the corners lifted, take the opening tool and pry each corner off.
Repeat this for the corner diagonal from the initial corner.
Once both corners are pried off, gently take the back case off the device.
Step 3:
Using the iFixit opening tool, disconnect the battery from the circuit board.
Step 4:
Disconnect the camera from the motherboard by unplugging the orange wiring.
Heat the area of the back camera up loosening the glue holding it in place.
Be careful when using hot tools and removing hot parts.
Step 5:
Once disconnected from the motherboard and heated up, use [product|IF145-020|tweezers] to remove the old camera.
Be careful when using hot tools and removing hot parts.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $36-$150)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($60-$250)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your Amazon Fire HD 8 (10th Gen) instead of replacing it, you're preventing approximately 81 kg of CO₂ emissions. Manufacturing a new Amazon Fire HD 8 (10th Gen) generates 85 kg of CO₂, while this repair only produces about 4 kg of CO₂. That's a 95% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your Amazon Fire HD 8 (10th Gen) and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.