Acer Aspire 3 Keyboard Replacement
Complete guide to Acer Aspire 3 keyboard replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Keyboard Replacement is one of the most common repairs for Acer Aspire 3. This repair involves replacing the damaged input component with a new or refurbished part. The process typically takes 2-4 hours and requires difficult skill level.
What You'll Need
- Replacement input part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Begin with the device face down.
Orient the laptop so that the battery is on the side opposite of you and the headphone ports are facing towards you.
Step 2:
Slide the button found below the battery to the left into the unlocked position.
You will know the battery is unlocked if the tab is pushed to the side where the symbol is unlocked.
Step 3:
Locate the battery and the tab to the right of it.
Pull the tab to the right while simultaneously pushing the battery away from you.
Make sure you push the battery only when tab is held in the right position in order to avoid damage to the device.
Step 4:
Lift the laptop to be on its edge, with the bottom of the screen in the air.
Step 5:
Remove the three 4.6 mm Phillips #1 screws that are on this edge.
Step 6:
Wedge a spudger into the latch on the right side.
Open the lid completely to facilitate removal.
Pull the handle of the spudger towards you to pop the first of the tabs that hold this piece in place.
Starting from right to left, pop the remaining tabs by lifting up on the panel and rotating the panel to the left.
Step 7:
Unscrew the two 4.6 mm Phillips #1 screws.
Step 8:
Gently lift the top edge of the keyboard out of its place.
Do not completely remove the keyboard as there is still a ribbon cable connecting it to the device.
Step 9:
Lift the ZIF connector's black retaining flap. Then gently slide the ribbon cable out.
Remove the keyboard.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $120-$360)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($200-$600)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your Acer Aspire 3 instead of replacing it, you're preventing approximately 240 kg of CO₂ emissions. Manufacturing a new Acer Aspire 3 generates 255 kg of CO₂, while this repair only produces about 15 kg of CO₂. That's a 94% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your Acer Aspire 3 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.