Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Brakes
moderate

2023 Ford Fiesta Brake Pad Replacement

Complete guide to 2023 Ford Fiesta brake pad replacement. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$150 - $300
⏱️ Time:1-2 hours
🌍 CO₂ Saved:6195 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$90 - $180
Labor$60 - $120
Total Estimated Cost$150 - $300

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Brake Pad Replacement is one of the most common repairs for 2023 Ford Fiesta. This repair involves replacing the damaged brakes component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.

🔧 Required Tools

🔩 Replacement Parts

What You'll Need

  • Replacement brakes part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1

Park the car where you have room to work.

Check that the hand brake is on and the engine is off.

Wait for the car to cool down before opening the hood. The hot air from the engine may damage the eyes and cause burns.

Ensure that the car has rested for at least 30 minutes.

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Pull the hood release under the driver's dashboard towards you.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

Make sure there is space to insert fingers. If not, repeat step 2.

Push the yellow hood release to the left to open the hood.

Step 4:

Step 4 - Image 1
Step 4 - Image 2

Lift the hood with one hand and place the strut upright in the correct position.

Place strut in the hole to the left of the hood.

Step 5:

Step 5 - Image 1
Step 5 - Image 2

Use a flathead screwdriver to loosen the lower retained screw.

Collect the screws and store them somewhere safe.

Step 6:

Step 6 - Image 1
Step 6 - Image 2

Remove the upper retained screw.

Store the screw in a safe place.

Step 7:

Step 7 - Image 1
Step 7 - Image 2

Carefully remove the headlight.

The headlight is attached to three electrical connectors.

Gently pull up and towards your body.

Set the headlight to the side.

Step 8:

Step 8 - Image 1
Step 8 - Image 2

Press both ends of the bulb container to remove the electrical connector from the bulb container.

Step 9:

Step 9 - Image 1
Step 9 - Image 2

Pull out the bulb from the headlight.

Press both ends of the electrical connector to separate from the bulb container.

Step 10:

Step 10 - Image 1

Make sure you do not hold the glass surface with your bare hands. The bulb may malfunction from the sweat in your hands.

Hold the black part of the bulb.

The bulb might break, so be sure to wear gloves and protective glasses.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Moderate | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $90-$180)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($150-$300)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your 2023 Ford Fiesta instead of replacing it, you're preventing approximately 6195 kg of CO₂ emissions. Manufacturing a new 2023 Ford Fiesta generates 6200 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 100% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your 2023 Ford Fiesta and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides