2022 Mazda CX-5 Brake Pad Replacement
Complete guide to 2022 Mazda CX-5 brake pad replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Brake Pad Replacement is one of the most common repairs for 2022 Mazda CX-5. This repair involves replacing the damaged brakes component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
What You'll Need
- Replacement brakes part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Pull the hood release lever located on the lower left side of the driver’s seat.
Move to the front of the vehicle and reach under the hood to release the safety latch.
Lift the hood and securely prop it open using the support rod.
Step 2:
Find the large black plastic air filter housing on the driver's side of the engine bay.
Identify the air intake duct connected to the housing.
Step 3:
Use a Phillips #2 screwdriver to loosen the hose clamp securing the intake hose to the air filter housing cover.
Remove the three 16.0 mm Phillips #2 screws securing the top cover of the housing.
Release the spring‑loaded tension tab if present.
Step 4:
Remove the air intake duct from the housing cover.
Gently lift the housing cover. You may need to tilt it back slightly to free the rear tabs.
Remove the old air filter with both hands.
Inspect the inside of the airbox for dust, leaves, or debris and clean it out manually.
Step 5:
Place the new air filter into the housing in the same orientation as the old one.
Ensure the rubber seal seats evenly around the edges to prevent unfiltered air from entering the engine.
Step 6:
Lower the housing cover and ensure the rear tabs align properly.
Reinstall and tighten the three 16.0 mm Phillips #2 screws.
Re‑engage any clips or the tension tab.
Reconnect and tighten the hose clamp securely. Avoid over‑tightening.
Step 7:
Close the hood.
Make sure the safety latch is clicked into place.
Start your vehicle and listen for any unusual sounds, everything should run smoothly.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $90-$180)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($150-$300)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your 2022 Mazda CX-5 instead of replacing it, you're preventing approximately 5595 kg of CO₂ emissions. Manufacturing a new 2022 Mazda CX-5 generates 5600 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 100% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your 2022 Mazda CX-5 and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.