Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Lighting
easy

2020 Honda Pilot Headlight Bulb Replacement

Complete guide to 2020 Honda Pilot headlight bulb replacement. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$20 - $100
⏱️ Time:15-30 min
🌍 CO₂ Saved:5799 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$12 - $60
Labor$8 - $40
Total Estimated Cost$20 - $100

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Headlight Bulb Replacement is one of the most common repairs for 2020 Honda Pilot. This repair involves replacing the damaged lighting component with a new or refurbished part. The process typically takes 15-30 min and requires easy skill level.

🔧 Required Tools

What You'll Need

  • Replacement lighting part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1
Step 1 - Image 2

Use a plastic pry tool to detach the light cover.

Be careful not to pry too hard, otherwise you risk breaking the cover.

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Use the pry tool to the light and attach the new one inside of the clamps that hold the bulb.

Repeat the same process for the left side bulb.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

Remove the screws inside of the unit using a Phillips #00 screwdriver.

Step 4:

Step 4 - Image 1
Step 4 - Image 2

Open the sunglasses case.

Use a Phillips #00 screwdriver to remove the screws.

Keep track of the screws. The front ones are silver, while the black ones inside the sunglasses case are black.

Step 5:

Step 5 - Image 1

After the screws come undone, this is what the unit should look like.

Step 6:

Step 6 - Image 1
Step 6 - Image 2

Press down on the four cable clamps to detach them.

Do not use the wires to pull them out. You may risk damaging the cables connecting to the unit.

Step 7:

Step 7 - Image 1

After detaching all cables, the unit should look like this and come right off.

Step 8:

Step 8 - Image 1
Step 8 - Image 2

Insert a plastic pry tool inside this little slot. Once you do, flick up to release this middle part from the unit.

Step 9:

Step 9 - Image 1
Step 9 - Image 2

Insert a prying tool into the button switch. Then push out to flick out the button.

Once the button has fallen out, insert the new switches by sliding them back where the old ones were.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Easy | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $12-$60)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($20-$100)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your 2020 Honda Pilot instead of replacing it, you're preventing approximately 5799 kg of CO₂ emissions. Manufacturing a new 2020 Honda Pilot generates 5800 kg of CO₂, while this repair only produces about 1 kg of CO₂. That's a 100% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your 2020 Honda Pilot and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides