Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Engine
easy

2019 Honda CR-V Air Filter Replacement

Complete guide to 2019 Honda CR-V air filter replacement. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$20 - $50
⏱️ Time:15-20 min
🌍 CO₂ Saved:5799 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$12 - $30
Labor$8 - $20
Total Estimated Cost$20 - $50

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Air Filter Replacement is one of the most common repairs for 2019 Honda CR-V. This repair involves replacing the damaged engine component with a new or refurbished part. The process typically takes 15-20 min and requires easy skill level.

🔧 Required Tools

🔩 Replacement Parts

What You'll Need

  • Replacement engine part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1
Step 1 - Image 2

Open the hood by pulling the hood latch.

Oil may be hot if the engine has not cooled.

Keep vehicle in park and off unless otherwise noted.

Chock both back wheels with blocks of wood to prevent car from rolling.

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Let the vehicle cool for 15 minutes if needed. Clean the area around the oil cap. Remove the oil cap.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

Locate the dipstick and check oil level.

Step 4:

Step 4 - Image 1

Place the drain pain under the chassis and align with the drain bolt.

Step 5:

Step 5 - Image 1

Locate the drain bolt.

Step 6:

Step 6 - Image 1
Step 6 - Image 2

Remove the drain bolt with a 17mm socket wrench, and completely drain the oil.

Step 7:

Step 7 - Image 1

Remove the oil filter with a 45mm oil filter socket.

Step 8:

Step 8 - Image 1
Step 8 - Image 2

Replace the drain bolt with a new drain bolt gasket (crush washer); Honda Washer, Drain Plug (14MM) 94109-14000. Use the 17mm socket wrench to tighten.

Step 9:

Step 9 - Image 1
Step 9 - Image 2

Install the new filter in place of the old filter. Hand tighten instead of using the oil filter wrench.

Step 10:

Step 10 - Image 1
Step 10 - Image 2

Place the medium funnel and add new 0W-20 full synthetic engine oil. Add 4.2 quarts of oil.

Step 11:

Step 11 - Image 1

Replace the oil cap.

Step 12:

Step 12 - Image 1

Start the vehicle, and check for any leaks around the oil filter and oil drain plug.

Stop the vehicle and let the engine rest for 5 minutes.

Step 13:

Step 13 - Image 1
Step 13 - Image 2

Use the dip stick to double check oil level and add more if needed.

Make sure the oil level is in between the low and high marks on the dip stick. Replace the dip stick and close the hood.

Reset the oil life in the maintenance section of the vehicle computer.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Moderate | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $12-$30)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($20-$50)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your 2019 Honda CR-V instead of replacing it, you're preventing approximately 5799 kg of CO₂ emissions. Manufacturing a new 2019 Honda CR-V generates 5800 kg of CO₂, while this repair only produces about 1 kg of CO₂. That's a 100% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your 2019 Honda CR-V and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides