2019 Chevrolet Trax Tire Rotation
Complete guide to 2019 Chevrolet Trax tire rotation. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Tire Rotation is one of the most common repairs for 2019 Chevrolet Trax. This repair involves replacing the damaged tires component with a new or refurbished part. The process typically takes 30-45 min and requires easy skill level.
What You'll Need
- Replacement tires part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Use a spudger to remove the cap for the screw.
Step 2:
Use a socket wrench with an 8mm (5/16) socket to remove the first screw.
Step 3:
Use a spudger to pry open the multiple clips on the trunk liner.
Repeat the process until the liner is entirely removed.
Step 4:
Squeeze and pull the clip away to disconnect the electrical wire from the trunk liner.
Step 5:
Pull down the red lock piece to disconnect the head light to the electrical.
Use a small pin to push down and pull the two parts apart.
Step 6:
Remove the bolts that are holding the taillight in place with a socket wrench that has an 8 mm (5/16) socket attachment.
Step 7:
Remove the second bolt holding down the taillight with a socket wrench that has an 8mm (5/16) socket attachment.
Step 8:
Remove the two bolts located in the middle of the trunk. This allows the taillight to be removed by using a socket wrench with an 8 mm (5/16) socket attachment.
Step 9:
To make even more room for the taillight, use a pair of pliers to squeeze the tab and push out the white cap.
Step 10:
Unclip the headlight by using a spudger to pry the clip back.
Step 11:
Apply gentle pressure upward and wait until you hear a suctioning sound.
When you hear the sound, push up and slide the taillight out simultaneously.
Step 12:
Insert the new taillight, then connect it to the electrical wire and push up the red lock.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Difficult | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $21-$45)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($35-$75)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your 2019 Chevrolet Trax instead of replacing it, you're preventing approximately 6099 kg of CO₂ emissions. Manufacturing a new 2019 Chevrolet Trax generates 6100 kg of CO₂, while this repair only produces about 1 kg of CO₂. That's a 100% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your 2019 Chevrolet Trax and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.