2018 Chevrolet Traverse Brake Pad Replacement

Brake Pad Replacement is one of the most common repairs for 2018 Chevrolet Traverse. This repair involves replacing the damaged brakes component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.

🔩 Replacement Parts

What You'll Need

• Replacement brakes part (OEM or aftermarket)
• Precision screwdriver set (Phillips #000 or pentalobe)
• Opening tools (plastic spudger, suction cup)
• Adhesive strips or glue
• Clean workspace with good lighting

Step-by-Step Process

Step 1:

Open the glove compartment.

Step 2:

Using your fingers, twist the two fasteners counterclockwise then pull to remove them.

Step 3:

On the right side of the glove box, there is a damper. Pull the damper up and then out.

This will allow the glove box to fully extend downward.

To avoid damage, secure the glove compartment box with your free hand so that it does not drop when you release the damper.

Step 4:

Use both hands to pull down on the plastic cabin air filter cover to remove the it.

Step 5:

Remove the old cabin air filter and properly dispose of it.

Step 6:

Insert the new cabin air filter into the compartment.

Pay special attention to the directions on the cabin air filter. The writing should be facing you and the air-flow arrow should be facing downwards.

DIY vs Professional Repair

Environmental Impact

By choosing to repair your 2018 Chevrolet Traverse instead of replacing it, you're preventing approximately 6095 kg of CO₂ emissions. Manufacturing a new 2018 Chevrolet Traverse generates 6100 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 100% reduction in carbon emissions!