2014 Chevrolet Suburban Battery Replacement (Car)

Battery Replacement (Car) is one of the most common repairs for 2014 Chevrolet Suburban. This repair involves replacing the damaged electrical component with a new or refurbished part. The process typically takes 30 min and requires easy skill level.

🔧 Required Tools

🔩 Replacement Parts

What You'll Need

• Replacement electrical part (OEM or aftermarket)
• Precision screwdriver set (Phillips #000 or pentalobe)
• Opening tools (plastic spudger, suction cup)
• Adhesive strips or glue
• Clean workspace with good lighting

Step-by-Step Process

Step 1:

Locate the wiring harness bundle, which exits the firewall underneath the brake booster.

Step 2:

Identify the auxiliary wire, which is folded and taped to either the wiring harness or the fire wall.

Step 3:

Use a knife to cut the tape away from the wire and unravel it.

Step 4:

Run the wire against the battery box.

Step 5:

Place the ring terminal (washer end) of the wire on the right post located at the front of the battery.

Place the 10 mm washer on the post.

Tighten the washer using a 10 mm wrench, crescent wrench, or pliers.

Post size and location may vary slightly in different models. The washer will fit snuggly around the correct post.

Step 6:

After hooking up the wire, check to make sure the 40 amp fuse is installed for the auxiliary pin.

If the fuse is not installed, there will be an empty space. This fuse can be purchased at any automotive shop.

DIY vs Professional Repair

Environmental Impact

By choosing to repair your 2014 Chevrolet Suburban instead of replacing it, you're preventing approximately 6085 kg of CO₂ emissions. Manufacturing a new 2014 Chevrolet Suburban generates 6100 kg of CO₂, while this repair only produces about 15 kg of CO₂. That's a 100% reduction in carbon emissions!