2013 Toyota 4Runner Spark Plug Replacement
Complete guide to 2013 Toyota 4Runner spark plug replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Spark Plug Replacement is one of the most common repairs for 2013 Toyota 4Runner. This repair involves replacing the damaged engine component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
🔧 Required Tools
What You'll Need
- Replacement engine part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
First the Idler arm must be removed from the truck. Another guide has instructions to [https://www.ifixit.com/Guide/1984-1989+Toyota+4Runner+Idler+Arm+Replacement/53763| take the arm off.]
Step 2:
Place the arm in a vise.
Spray the cap with penetrating lubricant.
Using a screw driver, tap the idler arm bracket cap off.
If it will not come off easily, then check out the [https://www.ifixit.com/Wiki/1984-1989_Toyota_4Runner_Troubleshooting|trouble shooting page.]
Step 3:
Using a 19 mm socket, take the nut off from inside the idler arm bracket.
If the arm rotates in the bracket, then it can be taken out of the vice and placed on the ground.
Once on the ground, your foot can be used to stop the arm from rotating and enable you to put torque on the nut.
Once the nut is off, the arm can be gently tapped out of the bracket.
Step 4:
Remove the oil seal.
Remove the plastic bushings with a flat head.
Both bushings and oil seals should be removed and replaced.
Fill the bracket with MP grease and then put the arm back into the bracket.
Wipe off any grease that squeezes out of the bracket.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $60-$120)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($100-$200)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your 2013 Toyota 4Runner instead of replacing it, you're preventing approximately 5998 kg of CO₂ emissions. Manufacturing a new 2013 Toyota 4Runner generates 6000 kg of CO₂, while this repair only produces about 2 kg of CO₂. That's a 100% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your 2013 Toyota 4Runner and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.