2013 Ford Focus Brake Pad Replacement
Complete guide to 2013 Ford Focus brake pad replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Brake Pad Replacement is one of the most common repairs for 2013 Ford Focus. This repair involves replacing the damaged brakes component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
🔧 Required Tools
What You'll Need
- Replacement brakes part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Unlock the car using the unlock button on the key fob or inserting the key into the door.
Open the car door.
The stereo panel is attached to the center dashboard.
Step 2:
Use the T20 Torx screwdriver to remove the two 19 mm torx screws under the lip of the stereo panel.
Set aside these screws for reassembly.
Step 3:
Carefully lift the panel up and out.
There is a wire attached to the back of panel.
Unplug the stereo connector from the panel and set aside the panel.
There are two Torx screw's attached to the stereo box.
Step 4:
Use the Torx T20 screwdriver to unscrew the top left and top right 19 mm screws.
Slowly remove the stereo box from the screw connectors.
Step 5:
Once the stereo box is removed from connectors, there will be 3 cords attached to the box.
The yellow wire will require some force to open because it serves as the power connector for the stereo.
Carefully push down on the clamp to disconnect the yellow wire on the far left of the box.
Push down on the clamps in the middle to remove the middle wire.
Push down on the clamps in the middle to remove the far right wire.
Step 6:
Once the wires are disconnected, safely remove the stereo box.
In order to proceed to the next step, reassemble the new stereo by following the steps in reverse order.
Step 7:
It is safe to turn the car on once the stereo has been reinstalled.
Press the center stereo button to turn the stereo on.
Press the menu button.
Press the OK button on SYNC-Media.
Step 8:
Use the arrow buttons on the stereo panel to navigate to the " Bluetooth Device" page.
Press OK on the " Bluetooth Device" page.
Navigate to the "Add Bluetooth Device" page using the arrow buttons and press OK.
Follow on screen prompt to connect to Bluetooth.
Refer to the introduction for a guide on how to connect to SYNC-Phone.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $90-$180)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($150-$300)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your 2013 Ford Focus instead of replacing it, you're preventing approximately 6195 kg of CO₂ emissions. Manufacturing a new 2013 Ford Focus generates 6200 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 100% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your 2013 Ford Focus and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.