Skip to main content
🔧
HowMuchToFixAI for a Greener Future
Maintenance
easy

2013 BMW 3 Series Oil Change

Complete guide to 2013 BMW 3 Series oil change. Cost estimates, difficulty level, time required, and environmental impact.

💰 Cost:$35 - $75
⏱️ Time:30-45 min
🌍 CO₂ Saved:6498 kg

🌍 Share Your Environmental Impact

Inspire others to repair instead of replace! Share how much CO₂ you're saving.

Share your impact:

💰 Cost Breakdown

Parts$21 - $45
Labor$14 - $30
Total Estimated Cost$35 - $75

💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.

🔧 Repair Overview

Oil Change is one of the most common repairs for 2013 BMW 3 Series. This repair involves replacing the damaged maintenance component with a new or refurbished part. The process typically takes 30-45 min and requires easy skill level.

🔧 Required Tools

What You'll Need

  • Replacement maintenance part (OEM or aftermarket)
  • Precision screwdriver set (Phillips #000 or pentalobe)
  • Opening tools (plastic spudger, suction cup)
  • Adhesive strips or glue
  • Clean workspace with good lighting

Step-by-Step Process

Step 1:

Step 1 - Image 1
Step 1 - Image 2

Unlock your trunk.

This can be done with either the remote or the trunk release button located on the driver's side footwell area.

Using the trunk handle, lift the trunk to it's highest position.

Step 2:

Step 2 - Image 1
Step 2 - Image 2

Using the appropriate trim tool, carefully remove all ten rivets from the trunk liner.

Step 3:

Step 3 - Image 1
Step 3 - Image 2

Pull on the green tab to release the inner trunk release handle.

After this, the trunk liner should be loose.

Carefully remove the liner and put it off to the side for later reassembly.

Step 4:

Step 4 - Image 1
Step 4 - Image 2

Using either a 10 mm socket or an open-end 10 mm wrench, turn the nut counterclockwise to loosen it and remove the bracket that secures the inner taillight.

An open-end wrench was used in this guide, however, both tools work for removing the retaining nut.

Step 5:

Step 5 - Image 1
Step 5 - Image 2

From underneath the inner taillight, push the housing with enough upward force to separate it from its socket.

Be careful when pushing the housing, as the connector is still attached to the inner taillight.

Step 6:

Step 6 - Image 1
Step 6 - Image 2

Tilt the inner taillight enough to gain access to the connector on the underside.

Firmly press the locking tab in the center of the connector.

Pull downwards on the connector to disconnect the inner taillight housing.

Step 7:

Step 7 - Image 1

Prepare your new taillight for reassembly.

Responsibly recycle your old inner taillight if it is no longer functional.

📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.

iFixit Difficulty: Moderate | Time: NaNh NaNm

DIY vs Professional Repair

✋ DIY Repair

  • ✅ Lower cost (parts only: $21-$45)
  • ✅ Learn new skills
  • ❌ Risk of further damage
  • ❌ No warranty
  • ❌ Requires tools and time

🔧 Professional Repair

  • ✅ Expert installation
  • ✅ Warranty included
  • ✅ Faster turnaround
  • ❌ Higher cost ($35-$75)
  • ❌ Need to find reputable shop

Environmental Impact

By choosing to repair your 2013 BMW 3 Series instead of replacing it, you're preventing approximately 6498 kg of CO₂ emissions. Manufacturing a new 2013 BMW 3 Series generates 6500 kg of CO₂, while this repair only produces about 2 kg of CO₂. That's a 100% reduction in carbon emissions!

Get a Personalized Repair Estimate

Upload a photo of your 2013 BMW 3 Series and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.

Related Repair Guides