2012 Ford Ranger Brake Pad Replacement
Complete guide to 2012 Ford Ranger brake pad replacement. Cost estimates, difficulty level, time required, and environmental impact.
🌍 Share Your Environmental Impact
Inspire others to repair instead of replace! Share how much CO₂ you're saving.
💰 Cost Breakdown
💡 Tip: Costs vary by location and repair shop. Authorized service centers typically charge more than independent repair shops.
🔧 Repair Overview
Brake Pad Replacement is one of the most common repairs for 2012 Ford Ranger. This repair involves replacing the damaged brakes component with a new or refurbished part. The process typically takes 1-2 hours and requires moderate skill level.
What You'll Need
- Replacement brakes part (OEM or aftermarket)
- Precision screwdriver set (Phillips #000 or pentalobe)
- Opening tools (plastic spudger, suction cup)
- Adhesive strips or glue
- Clean workspace with good lighting
Step-by-Step Process
Step 1:
Turn the window crank handle so the back side faces you. You will see that the window crank consists of two pieces connected by a head with snap-on tabs.
Use a small prying tool or a flathead screwdriver to fit into the small opening and gently pry the head of the crank handle apart.
If the window crank is not entirely separated by prying it from one side only, you will need to use the same tool to gently pry the other side as well.
Step 2:
Use either a prying tool or a flat-head screwdriver, preferably one with a larger head for more leverage. Insert the tool between the window crank handle and the plastic washer, and gently pry the head of the window crank apart.
Do the same for the other side.
Step 3:
Inside the hole is the Torx screw that mounts the window crank handle to the door panel. Use a T20 Torx screwdriver to take off the Torx screw.
Take out the window crank handle.
Step 4:
Place the plastic washer on the back of the window crank handle, where it fits between the crank and the door panel.
Install the window crank handle replacement.
Ensure the window crank handle is installed in the desired position.
Step 5:
As in step 3, use the T20 Torx screwdriver to insert the M4 x 16 mm Torx screw into the same hole. Be sure to handle the Torx screw gently when installing it.
Step 6:
Line up the top piece of the window crank handle with its bottom half and gently snap the clips into place to secure the connection.
Test the window crank handle to ensure the window is operating correctly.
📖 Repair guide provided by iFixit - The free repair manual. Licensed under CC BY-NC-SA 3.0.
iFixit Difficulty: Moderate | Time: NaNh NaNm
DIY vs Professional Repair
✋ DIY Repair
- ✅ Lower cost (parts only: $90-$180)
- ✅ Learn new skills
- ❌ Risk of further damage
- ❌ No warranty
- ❌ Requires tools and time
🔧 Professional Repair
- ✅ Expert installation
- ✅ Warranty included
- ✅ Faster turnaround
- ❌ Higher cost ($150-$300)
- ❌ Need to find reputable shop
Environmental Impact
By choosing to repair your 2012 Ford Ranger instead of replacing it, you're preventing approximately 6195 kg of CO₂ emissions. Manufacturing a new 2012 Ford Ranger generates 6200 kg of CO₂, while this repair only produces about 5 kg of CO₂. That's a 100% reduction in carbon emissions!
Get a Personalized Repair Estimate
Upload a photo of your 2012 Ford Ranger and get an AI-powered cost estimate in seconds. See exactly what's damaged and how much it'll cost to fix.