2010 BMW 5 Series Oil Change

Oil Change is one of the most common repairs for 2010 BMW 5 Series. This repair involves replacing the damaged maintenance component with a new or refurbished part. The process typically takes 30-45 min and requires easy skill level.

🔧 Required Tools

🔩 Replacement Parts

What You'll Need

• Replacement maintenance part (OEM or aftermarket)
• Precision screwdriver set (Phillips #000 or pentalobe)
• Opening tools (plastic spudger, suction cup)
• Adhesive strips or glue
• Clean workspace with good lighting

Step-by-Step Process

Step 1:

Open the trunk of the car to access the tail lights.

Remove the two 5 mm screws holding the panel cover in place.

Step 2:

With a flathead screwdriver, turn the screws half a turn counterclockwise.

Step 3:

With plyers, remove the screws.

Step 4:

Pull up the trunk matt and remove it from the corner.

Pull up the panel by the tab.

The panel should lift right out.

Step 5:

You will see the light bulb holster.

Turn the dial in the middle of of the black plastic light bulb holster.

Pull the holster out of the trunk bay.

Step 6:

Grab the light bulb at the base and twist counterclockwise.

DO NOT TWIST THE BULB BY THE GLASS.

Step 7:

Pull out the bulb and repeat the process in reverse order with the new bulb to reassemble.

DIY vs Professional Repair

Environmental Impact

By choosing to repair your 2010 BMW 5 Series instead of replacing it, you're preventing approximately 6498 kg of CO₂ emissions. Manufacturing a new 2010 BMW 5 Series generates 6500 kg of CO₂, while this repair only produces about 2 kg of CO₂. That's a 100% reduction in carbon emissions!